Product features

• ? User friendly 7” color touch panel display
  
• ? Support multi-language & facilitate users
  
• ? Built-in environment self-test program
  
• ? Programmable operation
  
• ? Pre-programmed IEC standard test levels, easy to operate
  
• ? RS232/USB interface, PC control operation & printable test report
  
• ?

Product parameters

• Model
  

  Voltage variation range
  

  Voltage change duration
  

  Switching phase
  

  Built-in standard test level
  

  Fall/rise time
  

  Voltage changes in the number of repeats
  

  Interval cycle of voltage variation
  

  Voltage dips mode
  

  EUT capacity
  

  Power supply
  

  Ambient temperature
  

• VDT T20
  

  0~120%
  

  1~9999 half cycle
  

  0~359°synchronous, asynchronous, or automatic
  

  0%, 40%, 70%, 80%, 120%
  

  1μs~5μs for abrupt changes
  

  1~9999*9999
  

  1~9999 half cycle (HC)
  

  Freely set
  

  3-phase, 20A (custom specific on demand)
  

  AC220V 50/60Hz
  

  15℃~35℃
  

Product recommendation

Single phase 8Kv lightning surge generator sur S8

Model：SUR S8

The impact of lightning (indirect lightning) in nature and voltage changes caused by large switch switching in power supply lines on power supply lines and communication lines is particularly large, and the impact on products may be destructive. The lightning surge generator is used to evaluate the performance of the equipment when it is subjected to high-energy disturbance from the power line port and other signal line ports. The product meets the requirements of new standards such as iec61000-4-5 and gb/t17626.5.

Learn more

Impulse current generator sur 6ka

Model：SUR 6KA

The lightning surge generator sur 6ka is used to inspect the anti surge protection devices such as zinc oxide arrester valve piece, varistor, SPD, TVs tube, gas discharge tube, etc. for surge impact test. The product produces 8/20us surge pulse waveform, and the technical indicators of the waveform comply with the provisions of national standards and IEC standards.

Learn more

Single phase 6kV burst generator EFT S6

Model：EFT S6

In the circuit, such as from the switching transient process (cutting off inductive loads, bouncing relay contacts, etc.), it will usually interfere with other electrical and electronic equipment in the same circuit. This kind of interference is characterized by high amplitude, short rise time, high repetition rate and low energy. Clusters of narrow pulses can charge the junction capacitance of semiconductor devices, which may cause circuit or equipment errors when accumulated to a certain extent. The burst generator determines a common reproducible evaluation basis for evaluating the performance of power supply ports, signal, control and grounding ports of electrical and electronic equipment when disturbed by electrical fast transient bursts. The products meet the requirements of new standards such as iec61000-4-4, en60100-4-4 and gb/t17626.4.

Learn more